![]() ![]() Make sure the pocket screw holes face towards the inside. Line up part I (horizontal side beams) on either end and screw the plywood into them using screws with a flat head. Wipe the gorilla glue after applying so only a small seam remains.ĭrill 5 pilot holes for screws in each of the short sides of part H (1/4" plywood floor). Use a small amount of gorilla glue on the inside seam between the bottom of the plexi glass and the wood of part G (bottom horizontal support beam). The bottom side of the plexi glass will but right up to the floor piece of the table. Screw the top side of the plexiglass into place. Now mark and drill holes in the top support beam plexi glass over hang. Use the screws with a flat underside of the head to screw the plexi glass piece into place. Make sure there is a large overhang of plexi glass on the top support beam, and very little overhang on the bottom support beam. Line up the plexi glass on the flat side of the wood piece. Mark 5 drill holes on each short side of the plexi glass. Add 2" to the width and 1" to the height and get a piece of plexi glass cut to this size. Stain the side pieces with the color of your choice and let it dry completely. Repeat this step to assemble the other long side. ![]() Make sure to reinforce your joints with wood glue as you go. ![]() Again, place a piece of scrap 1" x 2" under part G so that the faces are level. Now place part G 2" from the bottom of part E (table leg). Screw part F into part E and repeat on the other side to make a "U" shape. Place a piece of scrap 1"x2" under part F so that the 2 pocket screw faces are about level. Pocket hole sides up line up part F with the top of part E (table leg). 1 -3' long set of 1/4" U track (optional)ġ - pack of 100 coarse 1 1/4" screws for pocket screw holesġ - large bottle of gorilla glue or similarġ - pack of hooks for hanging light sockets and decorġ - pack of 1/2" screws with a flat underside of the headġ - can of plastic spray paint (optional) 2-plexi glass pieces of 19.5" x 3" (optional) Lumber - Use any kind of wood you like, popular choices are cedar, pine or oak:Ģ-plexi glass pieces cut to size of long sideĤ-plexi glass pieces cut to size of short side doors (about 10.5" x 13.5") ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |